沼氣發電機組經過一段時間使用后，出現耗氣量過高的現象，這時要檢查沼氣發電機組狀況，下面來講解下吧。

After a period of use, the gas consumption of the biogas generator unit is too high. At this time, check the condition of the biogas generator unit. Let's explain next.

1)檢查沼氣發電機組水溫是否低于80℃，使減壓器加熱不良，或減壓器循環水管被堵，造成減壓器有結冰，混合氣偏濃。

1) Check whether the water temperature of the biogas generator unit is lower than 80 ℃, which causes poor heating of the pressure reducer, or the circulating water pipe of the pressure reducer is blocked, resulting in icing of the pressure reducer and rich mixed gas.

2)高低壓沼氣管線、混合器與節氣門連接處、進氣管、沼氣裝置及鋼瓶是否漏氣。

2) Check whether the high and low pressure biogas pipeline, the connection between the mixer and the throttle valve, the intake pipe, the biogas device and the steel cylinder leak.

3)空氣濾清器是否干凈，進氣管路是否暢通。

3) Whether the air filter is clean and whether the air inlet pipeline is unblocked.

4)混合器流量是否調整不當，使混合氣過濃。在保證正常啟動的情況下，再在混合器膜片上加0.1mm厚銅墊或適當關小功率閥。

4) Whether the mixer flow is adjusted improperly to make the mixture too rich. Under the condition of normal startup, add 0.1mm thick copper pad on the mixer membrane or properly close the power valve.

5)中冷增壓沼氣發電機組減壓器出口壓力高，高可達80Kpa，使用檢漏液檢查沼氣出口到進氣管之間各部件是否有漏氣，用壓縮空氣檢查。

5) The outlet pressure of the pressure reducer of the intercooled supercharged biogas generator set is high, up to 80kPa. Use leakage detection liquid to check whether there is air leakage in all parts between the biogas outlet and the intake pipe, and use compressed air to check.

6)低壓減壓器輸出壓力是否過高。

6) Whether the output pressure of the low pressure reducer is too high.

7)檢查蓄電池電壓是否過低和點火系統是否有故障。

7) Check whether the battery voltage is too low and whether the ignition system is faulty.

8)斷缸法檢查各缸工作情況。

8) Check the working condition of each cylinder by cylinder breaking method.

9)所有沼氣發電機組動力不足，均會引起耗氣量增加。

9) Insufficient power of all biogas generating units will cause an increase in gas consumption.

上述檢查完成后，若仍沒有解決沼氣耗氣量高的問題，則可能是沼氣發電機組技術狀況下降，需要檢查氣門間隙，各缸的氣缸壓力。關注我們http://biandang123.cn，了解更多內容點！

After the above inspection, if the problem of high gas consumption of biogas is still not solved, it may be that the technical condition of biogas generator unit has decreased, and it is necessary to check the valve clearance and the cylinder pressure of each cylinder. Follow us http://biandang123.cn Yes, learn more!